Best Way To Remove Vinyl Tile Adhesive From Concrete Floor

If there are still several tiles stuck to the floor place a piece of dry ice on the tile.

Best way to remove vinyl tile adhesive from concrete floor.

You can use a commercial adhesive stripper or use acetone to soften and remove the glue as well as an electric hand sander for tough to remove spots. If that doesn t get the glue off you will need to use a commercial adhesive stripper to soften and remove the glue. Work the chisel between the tiles and the concrete hammering them up with a 2 lb. Work the chisel under the tiles forcing them loose.

With vinyl the answer is fire or heat if you will. In these cases a solvent is needed to break down the glue so it can be scraped up. If removal is more difficult use a heat gun to soften the adhesive. Soften the tile adhesive by blowing it with the hottest setting on the hair dryer and then scrape it with the putty knife.

However getting the adhesive off the concrete may prove to be more difficult. Scrape the remaining glue with a floor scraper or pry bar. Thus you can easily sweep away the glue. You can aim a blow gun at the vinyl or put it under several layers of paper and pass an iron over the top.

So removing this glue from the floor you need to use a commercial adhesive stripper to soften the glue. Masonry chisel and a 2 lb. Depending on the adhesive a scraping is all you may need to remove it. Never allow for a hot object to come into actual contact with vinyl.

The tile should pop off easily leaving the glue in place. Start at a broken tile or between tiles where the grout has loosened. The adhesive stripper will soften the glue and make it water soluble. Start by scraping the glue with a pry bar or scraper.

Strike the face of stubborn tiles to break them up for easier removal. Sweep up dust or chipped pieces that come free and dispose of it all in the trash. Sometimes heat and water are not enough to soften very old mastic and vinyl tile adhesive. Cut and pull up the vinyl in narrow strips to reveal the glue.

Check the floor for vinyl tiles that are still stuck to the floor. The adhesive will only work if applied directly to the glue on the subfloor. Use a 3 4 or 1 in. 4 repeat all steps until the tiles are completely removed from the.

Removing vinyl from concrete is similar to removing it from subfloor.